How do I reset my Eaton Ultra Shift?
Clearing Fault Codes Manually
- Place shift lever in neutral.
- Set parking brake.
- Turn key on with engine off.
- Turn key off and on 6 times within 5 seconds ending with key on.
- Turn the key off and allow the system to power.
What does F mean on a Eaton transmission?
Active fault code
Flashing “F” in Gear Display Indicates that the transmission has detected an Active fault code. This fault code can be accessed with the ServiceRanger diagnostic software.
How do you clear the AutoShift fault code?
Clearing Fault Codes Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds. 2. T urn the key OFF and allow system to power down.
How do you clear a transmission code?
Steps to Resetting Transmission Control Module
- Step 1: Turning Key Position.
- Step 2: Press gas pedal.
- Step 3: Keep Waiting.
- Step 4: Turning the Key Off.
- Step 5: Releasing Gas Pedal.
- Step 6: Wait Again.
- Step 7: Ready.
How do I reset my Allison transmission?
Allison Transmission Transmission Service Indicator Light Reset
- To reset the service indicator light.
- Turn the key on, do not start the engine.
- Move the shift selector to N-D-N-D-N-R-N, pausing briefly (less than 3 seconds) between each selector movement.
What is code 88 on Eaton AutoShift?
Fault Code 88 – CAN Inverter Message (HCM) Detection HCM ignition voltage is greater than 7 volts and less than 16 volts. HCM CAN data link fault is Inactive.
What does CA mean on automatic transmission?
“CA” will appear in the gear display if a clutch abuse event is occurring. “AN” will appear in the gear display if the transmission goes into Auto Neutral.
What does resetting a transmission do?
It records the driving style, usually by looking at the last 40 shift points and adjusts so the car shifts accordingly to your style. It does this by monitoring different sensors such as the throttle or the gas pedal input and more. In other words, it learns your driving style.
How to find fault code on Eaton Fuller transmission?
View or fault code page for instructions on retrieving and clearing fault codes in your Eaton Fuller transmission. Power-up no crank and gear display shows double dash “–”, double stars “**” or blank Transmission will not engage a gear from neutral and warning tone sounds (solid N in gear display)
What is the fault code for Eaton SMARTSHIFT?
Eaton Autoshift/ Smartshift/ Autoselect transmission Fault Codes list Fault code PID SID Imf Decoding 11 254 2,12 Internal malfunction of the device ECU 12 233 12 Gearbox ECU 13 236 4,5 Winding of the Power relay 14 18 12 Gear shift Lever
What is PD mode in Eaton ultrashift plus?
PD Mode is used to diagnose Inactive fault codes that may have set during normal operation. This diagnostic mode increases the fault sensing capability of the transmission system, making it more likely to detect intermittent electrical or wiring issues.
What does FMI mean on an Eaton transmission?
The FMI may indicate that a problem with an electronic circuit or an electronic component has been detected. The FMI may also indicate that an abnormal operating condition has been detected. View or fault code page for instructions on retrieving and clearing fault codes in your Eaton Fuller transmission.