How much does it cost to rebuild a 32RH?
Jasper Engines/Transmissions does still rebuild the 32rh, but the price is around $2300 delivered to a shop.
Is the 32RH a good transmission?
The 32RH has a hydraulic lock-up torque convertor (electric solenoid operated), and performs very well at highway speeds. One of the finest automatic transmissions ever made.
How much does it cost to rebuild a Jeep transmission?
The cost of your Jeep transmission repair or rebuild will depend on which parts need to be replaced and how many service hours the project will require. However, the average transmission replacement cost starts at about $1,800 and can cost as much as $3,400.
How do I know if I have a 32RH transmission?
The Chrysler 30RH/32RH transmission is a 3-speed automatic transmission with a gear type oil pump. The ID numbers are stamped on case’s left side just above the oil pan.
What vehicles have a 32RH transmission?
The Jeep Wrangler, Wagoneer and other models in the Chrysler family have successfully used the 32RH transmissions. The arrival of these used units is expected to create better opportunities for Dodge and Jeep 4×4 vehicle owners to purchase units online.
What did the 32RH transmission come in?
How long is a 32RH transmission?
|Small Block||30 3/4 in.||2 3/16 in.|
How long will rebuilt transmission last?
On average, a rebuilt transmission is expected to last between 30,000 – 50,000 miles. If the work is done extremely well and regular maintenance is performed, a transmission rebuild can last as long as the original transmission (120,000 – 200,000 miles on average).
How do I know what transmission I have in my Jeep Cherokee?
Locate the plate.
- Lay on the ground on either side of the Jeep.
- Slide under the Jeep to the transmission which is bolted to the motor. Look for a metal plate attached to the transmission. The transmission number is located on the plate. It is the only number on the plate. EX. 42RE.
What transmission does my Jeep Cherokee have?
Access the Jeep Cherokee’s transmission by looking underneath the Cherokee. Identification numbers for the AW4 and 30RH are located on the passenger’s side while 46RH and 42RE numbers are on the driver’s side of the transmission.
Do you have to rebuild a jeep 32RH?
I had a basic rebuild done that includes new TC, lock up solenoid and they also had to replace the valve body and one of the hydraulic pumps, the pump being the main problem. All of it was covered in the rebuild and i haven’t had any problems since. My 3-speed auto gave up the ghost on the way home today.
What kind of transmission does a 32RH have?
All fluid levels were good, did another flush anyway and was good for a week then started slipping again, not engaging in any gear. I just pulled the 32RH auto transmission and 231J transfer case. Turns out the torque converter in it is from an A500, mine is a A999. 1.
Where is the NPT on a 32RH Jeep?
Tap and thread a 90 degree 1/4 NPT to 3/8″ barb on the top of the trans, just behind the sun gear. It looks like there is lots of room there. I was thinking of putting it in the adapter housing but on a steep incline I think it might get blocked off when the fluid goes to the rear.