How wide are Jeep Wagoneer axles?

It is exactly 58″ from outside brake rotor to outside brake rotor, there is approximately 1.75″ on each side out to the WMS which gives you 61.5″.

What axles are in a Jeep Wagoneer?

SJ Wagoneer: Grand Wagoneers, Full Size Wagoneers and Full Size Cherokees/Cherokee Chiefs came standard with Dana 44 front axles, and either the Dana 44 or AMC 20 rear axles.

How wide is a Jeep rear end?

Stock XJ width is 58.5 inches WMS, I believe.

How wide are Jeep Cherokee axles?

You are correct they do vary quite a bit. Usually a full width is in the neighborhood of 66-67″ WMS for front axles and 65-66″ for the rear. Stock XJ axles are 60.625″ WMS, IIRC.

How wide is a Jeep Wrangler rear axle?

The width of the axle shafts is 1.13 inches. Dana 44: These are the beefier axles found on the rear of all Wrangler models now with either a 3.21 or 3.73 gear ratio. The Dana 44 ring gear size is 8 ½ inches.

How wide is a Jeep Wrangler axle?

This assembled axle is the stock JK width (65.5 inches), comes with a 35-spline ARB Air Locker and 5.38:1 gears.

How wide is a Jeep Cherokee axle?

Products specifications

Vehicle Fitment 1984 thru 2001 Jeep Cherokee XJ
Wheel Bolt Pattern Dual pattern, 5 on 4 1/2” and 5 on 5 ½”, 1/2″ studs installed in 5 on 4 1/2
Brake Space 2.5 inch axle standoff
Width 60.625 inches (between wheel mounting surfaces)
Fluid Capacity 3 quarts of 85w-140, non-synthetic (API GL-6 rated only)

What kind of rear axle does a Jeep Wagoneer have?

XJ Cherokee/Wagoneer: 1987-1989 (some say up until 1990) XJ Cherokees with the Tow Package sometimes came with the Dana 44 rear axle. These are now hard to come by because of Wrangler and Cherokee owners using them to upgrade their weak Dana 35s and because it’s an easy bolt-in swap for Cherokees and Wranglers.

How big is the rear axle on a jeep?

Several variations of the Dana 44 have been used as the rear axle in Jeeps, all of them use a 8.5″ ring and pinion. The Dana 44s with the two piece shafts are 19 spline or 27 spline and the versions wih the once piece shafts are 30 spline. The R&P ratio ranges supported by the carriers are 2.87-3.73 and 3.92-5.89.

How big is the wheelbase of a wagoneer?

Overall Length: 186.4 inches Overall width: 74.8 inches Wheelbase: 108.7 inches Rear axle to ground: 7.2 inches

What are the specs of a Dana Wagoneer?

Front: Dana model 44 full-floating solid axle. Multi-leaf special springs. Standard axle ratio 2.73:1 Rear: AMC semi-floating solid axle. Multi-leaf special springs. Standard axle ratio 2.73:1