What is a prodigy P2 used for?
The Prodigy P2 electric brake controller supplies power to your tow vehicle’s brakes proportionally. This means that your trailer brakes at the same time and with the same strength as your vehicle – even in reverse gear.
How do you troubleshoot a tekonsha brake controller?
Troubleshooting the Prodigy Brake Controller
- Check that the front of the controller is level side to side and back to front.
- Connect the trailer electrical connection plug to the tow vehicle and start the tow vehicle.
- Check the display reading.
- Check the display reading.
- Check the display reading.
How do I get rid of Prodigy P2?
To remove the Tekonsha Prodigy P2 # 90885 you simply need to detach the harness at the rear of the brake controller. Once that is removed you can tuck the harness up under your dash with some zip ties andthe uninstall the bracket that holds the brake controller as well.
How do I adjust my Prodigy P2?
Roll the adjustment wheel on the left up or forward (towards the front of the vehicle) to get it to 6. Then you will drive about 20 miles per hour nd fully apply the manual override lever at the bottom (do not use the brake pedal). If the brakes lock up adjust the power down by turning the wheel the other way.
What does E1 mean on a reliance brake controller?
trailer is not connected
The E1 error code on the Reliance brake controller indicates that a trailer is not connected. If the trailer WAS connected and you got the E1 code, a probable cause is a dirty trailer connector. Check the trailer connector on the trailer and on the vehicle. Clean out any dirt or corrosion.
What is a Voyager XP?
Proportional brake control with Raybestos Voyager XP keeps your stops smooth! These electric trailer brake controls employ a patented brake sensor to keep your stopping power relative to your pedal pressure for controlled, secure stops. And Voyager XP delivers 100 percent full stopping power faster!
How do you reset a prodigy brake controller?
The first step that we will want to take is to reset the brake controller. This is done by simply unplugging the brake controller for approximately 20 seconds and then reconnecting the brake controller.
Why does my trailer brake controller not work?
Brake controller loses connection to battery ground. Ground wire was not connected to negative battery terminal, ground area does not have solid connection to ground. Adapter wiring does not match OEM connector on vehicle. Ground wire has been damaged and exposed wiring is touching a metal area.
How does The Prodigy P2 brake controller work?
The Prodigy P2 electric brake controller supplies power to your tow vehicle’s brakes proportionally. This means that your trailer brakes at the same time and with the same strength as your vehicle – even in reverse gear. If you have to slam on your truck’s brakes, the trailer’s brakes respond instantly, too – there’s no delay.
What does boost indicator mean on Prodigy P2?
Meaning that the P2 is powered up and ready. The right dot is the Boost indicator. This tells you that there is a level of boost set. Display only goes up to 0.0 to 4.2 when applying brakes. With Proportional Type digital controls the vehicle must be in motion for the control to have output.
Where does the pigtail harness plug into a P2?
After selecting the proper optional (sold separately) harness for your vehicle, one end of the pigtail harness plugs directly into your vehicle, while the other plugs into your P2. Just unplug the unit to move it to another car, truck or SUV use or simple storage – no hard-wiring required.
