What is bs EN 1364-1?
BS EN 1364-1: 2015 Specifies a method for determining the fire resistance of non-loadbearing walls. BS EN 1365-1: 2012 Specifies a method for determining the fire resistance of loadbearing walls. BS EN 1365-2: 2014 Specifies a method for determining the fire resistance of loadbearing floors and roofs.
What is EN 1364?
EN 1364-1: Fire resistance tests for non-loadbearing elements – Part 1: Walls. EN 1364-1 describes procedures for determining the fire resistance of non-loadbearing elements of building construction when subjected to the heating and pressure conditions specified in EN 1364.
What is en1634?
BS EN 1634-3:2004 Fire resistance tests and smoke control tests for door and shutter assemblies, openable windows and elements of building hardware.
How is fire resistance tested?
What is Fire Resistance Testing? Fire resistance can be determined through destructive fire testing designed to replicate the product’s intended end-use. The specimen to be tested is built into an appropriate supporting construction which is then built into a restraint frame and mounted on the front of a furnace.
What is bs8214?
BS 8214 gives recommendations for the specification, installation and maintenance of fire doors. The recommendations are applicable only to hinged or pivoted pedestrian doorsets, door assemblies, or door leaves of any material, fitted into frames of any material.
What is en1154?
BS EN 1154 classifies door closers using a 6 digit coding system. Each digit refers to a particular feature of the product measured against the standard’s performance requirements. Seven test door mass grades and related door closer power sizes are identified.
What is flammability test?
Flammability testing determines how easily a material or finished product will ignite or burn when exposed to or used near fire or heat.
What is fire endurance test?
Fire endurance is defined by ASTM as “a measure of the elapsed time during which a material or assembly continues to exhibit fire resistance under specified conditions of test and performance. These temperatures are measured by nine thermocouples located in the furnace chamber at fixed distances from the specimen.
How do I know if my door is FD30?
All JELD-WEN fire doors will have a certification label on the top edge of the door leaf. This label will state the manufactures name and telephone number, the Certifre certification number and it will also state the fire rating of the door for example FD30 (30-minute fire resistance).
Can you cut down fire doors?
The short answer is: there is no general, recommended, or mandatory amount on a fire door that can be trimmed. This means that the fire door’s test certificate may be void because the door has been altered outside the scope of its certification and its performance may be affected, rendering the door illegal.
What is EN standard in door closer?
BS EN 1154 classifies door closers using a 6 digit coding system. Each digit refers to a particular feature of the product measured against the standard’s performance requirements. – grade 3: For closing doors from at least 105° open.