Where is the TPMS reset button on a 2013 Subaru Legacy?
Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
How do you reset the TPMS on a Subaru Legacy?
To reset the tire pressure monitor or tpms system in your 2017 subaru legacy vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
How do you reset the tire pressure sensor on a Subaru?
To Reset the Warning Light Perform the following two steps:
- Fill each tire to the recommended PSI/Air Pressure Levels. Do not forget the spare. Normally 32lbs in the Front tires and 30lbs in the Back.
- Drive the vehicle for 25/mph or more for a few minutes.
Why is my tire pressure light still on after filling tires Subaru?
When the TPMS warning light comes on it means that either one of the tires is under-inflated or there is a fault with the system. If the light is intermittent or if it stays on after correct inflation or replacement of a punctured tire then this indicates a fault with the TPMS system.
Do TPMS need to be programmed?
TPMS ID Protocols Sensor must be programmed or cloned from OE or another aftermarket sensor before use. (Programmable sensors have no protocols written to the sensor, whereas configurable sensors have several protocols written to the sensor.)
Can you turn off TPMS system?
The U.S. Department of Transportation has mandated that all vehicles manufactured after 2008 include a tire pressure monitoring system (TPMS). Although you cannot disable the TPMS in a General Motors (GM) vehicle, you can reset the system if you recently checked your tires and inflated them properly.
How to check tire pressure on a Subaru Legacy?
1) Set the tire pressure of all wheels to specification. 2) Connect the Subaru Select Monitor. 3) On the “MAIN MENU” screen, select “EACH SYSTEM CHECK” and press the YES (or OK) key. 4) On the “SYSTEM SELECTION MENU” screen, select “TIRE PRESSURE MONITORING” and press the YES (or OK) key.
How to register a TPMS on a Subaru Legacy?
8) Using the Transmitter Registration Tool (TPM-00012 or Kent-Moore Part No. FJ45295), contact the sidewall near the air valve of the front left tire and press the switch to send the transmitter ID to the TPMS control module (at this time, the tire pressure warning light blinks to start the registration procedure).
How to reset TPMs on Subaru Senso R?
Starting with the LF tire, use the scan tool to scan each senso r in the following order: LF, RF, RR, LR (and full size spare if equipped). Turn ignition to the ON position with the engine OFF (not the A CC position).
Why is the TPMS not working on my Subaru Outback?
Be careful not to damage the airbag system wiring harness when servicing the TPMS control module. Under the following conditions, the system may not function properly: If tire pressures are incorrect. If tires are damaged or punctured. Air pressure sensor malfunction. Air pressure sensor is out of battery power.
